Use and Description

RAILING WITH SECURITY HINGES FOR EXTERNAL OPENING 90°

The hinges are used in the safety grilles and gates to give a further rotation of the flying of 90°, granting as well as a lower swing of the footprint.

They are made of weldable material for a quick assembling, and are available for tubes of different sizes: 30×30, 30×40, 40×30, 40×40 mm.

When removing the central pin in stainless steel, it is possible to separate the doors of the structure to perform the burnishing treatment.

RAILING WITH LOCKING HINGE FOR 90° EXTERNAL OPENING

The hinges are made of iron welded to the tubes of different sizes: 30×30, 30×40, 40×30, 40×40 mm.

Besides allowing a 90° external rotation of the doors, they ensure a safe railing closing by means of the locking of the GB stainless steel pin in the seat frame.

By removing the center pin, the doors of the iron structure can be separated to effect the burnishing treatment.

The GB model is produced in only one version; once overturned, it can be used on the left and right side.

RAILING WITH LOCKING HINGE FOR OUTSIDE AND INSIDE OPENING OF 180°

The hinges are made of iron welded to the tubes of different sizes: 30×30, 30×40, 40×30, 40×40 mm.

Besides allowing a 180° external rotation of the doors, they ensure a safe railing closing by means of the locking of the CB stainless steel pin in the seat frame.

By removing the center pin, the doors of the iron structure can be separated to effect the burnishing treatment.

The CB model is produced in only one version; once overturned, it can be used on the left and right side.